Hi, I have successfully made a transparent BLE connection with the PmodBLE. 2 of my modules the P1_6/STATUS pin works as expected, low for connected and high for not connected.
Another 2 of my modules don't do this. One did until recently, but now it doesn't. They both report about 2.7V regardless of if they are connected or not (measured with a multimeter, I have not looked at it with a scope yet). In other respects they seem to work. I can transfer data. I am hoping I have inadvertently upset a setting. I have tried the reset (SF,1)and setting the UART Rx Indication Pin to UART RX Indication (SW,0C,04). This did not fix it.
Have I done the right thing?
What should I do?
Is there a way to read the setting set with SW,x,x? This way I could compare it with a good one.
Question
LanceH
Hi, I have successfully made a transparent BLE connection with the PmodBLE. 2 of my modules the P1_6/STATUS pin works as expected, low for connected and high for not connected.
Another 2 of my modules don't do this. One did until recently, but now it doesn't. They both report about 2.7V regardless of if they are connected or not (measured with a multimeter, I have not looked at it with a scope yet). In other respects they seem to work. I can transfer data. I am hoping I have inadvertently upset a setting. I have tried the reset (SF,1)and setting the UART Rx Indication Pin to UART RX Indication (SW,0C,04). This did not fix it.
Have I done the right thing?
What should I do?
Is there a way to read the setting set with SW,x,x? This way I could compare it with a good one.
Thanks in advance, Lance.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now