Arty S7 50 with Xilinx Programming Cable on J9 to see FPGA

[eesol]

I am unable to connect to the Arty S7 50 using a Xilinx programming cable. Vivado HW manager says no active target available. I need help determining what I am doing wrong. Thanks!

- Xilinx Programming Cable is connected to the J9 with flyleads per the latest schematics Rev E.1 (12/13/17) which patches the board (marked Rev E).

- Mode jumper is not installed so the board is not booting from QSPI

- Board is powered using barrel jack with no USB cable connected and indicates power good. 

- Xilinx programming cable driver installed as it shows up as programming cable in device manager. 

- Cable indicator is green.

HW manager returns the following information:

connect_hw_server
INFO: [Labtools 27-2285] Connecting to hw_server url TCP:localhost:3121
INFO: [Labtools 27-3415] Connecting to cs_server url TCP:localhost:3042
INFO: [Labtools 27-3414] Connected to existing cs_server.
localhost:3121
open_hw_target {localhost:3121/xilinx_tcf/Xilinx/Port_#0005.Hub_#0001}
INFO: [Labtoolstcl 44-466] Opening hw_target localhost:3121/xilinx_tcf/Xilinx/Port_#0005.Hub_#0001
ERROR: [Labtools 27-2269] No devices detected on target localhost:3121/xilinx_tcf/Xilinx/Port_#0005.Hub_#0001.
Check cable connectivity and that the target board is powered up then
use the disconnect_hw_server and connect_hw_server to re-register this hardware target.
ERROR: [Common 17-39] 'open_hw_target' failed due to earlier errors.

 

 

Edited April 23 by eesol

[eesol]

Update - tried a newer DLC10 USB programming cable as per the  GRMON3-UM page 40, but this still fails.

Also ran the libusb-win32-devel-filter-1.2.6.0.exe tool per GRMON3-UM to install the Xilinx programming cable but GRMON still fails.

FYI - I am using W10.