2x7 male connector with wire leads to mate with JTAG-HS3

[KX_1]

Hello.  I sent a question to support and was told to come here and post this question.  

I need to find a connector that will mate with the JTAG-HS3 programming assembly. The mating connector, if possible shall have wire leads instead of through-hole/board-mount terminals, or shall ha  soldercup contacts that I can solder wires to.  Any suggestions?  I have a photo uploaded of a similar Molex connector, and pointed to where I would like to have wires pre-terminated or soldercups. 

[JColvin]

Hi @KX_1,

Digilent does not have such an assembly for the JTAG HS3.

You may find this thread (mostly discussing the conversion of the 2 mm pitch JTAG header that Xilinx and thus the HS3 uses to a 2.54 mm pitch) of some help though:

Let me know if you have any questions.

Thanks,
JColvin