4-Wire RTD, USB-TEMP, Best SW to use?

[jnieves]

Hello everyone,

I recently acquired USB-TEMP (8 Channel Temperature Data Acquisition (DAQ) Module) to do testing with 4-wire RTDs.

The purpose is to have a setup for testing 8 probes (all 4-Wire RTDS) simultaneously.

I believe I setup InstaCal correctly and selected the sensor type and wiring configuration.

I wanted to know how I can use DAQami because the interface makes acquiring data easy but I don't see any RTD settings to select from.

 

[Fausto]

Hello @jnieves.

The following forum post was written for a MCC USB-TEMP-AI with DAQami, but can be applied to a MCC USB-TEMP module as well.

 

The following table shows the maximum number of supported channels based on configurations.

 

 

Regards,

Fausto