Issues in connecting USB-234 device to Matlab for data acquisition

[a.loconte2]

When I try to connect the usb 234 device to matlab(2023 rb) to perform an acquisition using the data acquisition toolbox the device is not recognized by the program which says there is no device connected (I already installed the proper package for measurement computing). Also i used the 'v=daqvendorlist' command and what I get is that the mcc vendor is 'not operational' (picture attached). Can someone please help me?

 

 

 

Edited February 5 by a.loconte2

[Fausto]

Hello @a.loconte2.

Please close MATLAB and install the current version of InstaCal.  Afterwards, connect your MCC USB-234 device to the target Windows system and launch InstaCal.  If the device is recognized by InstaCal, then close the application and launch MATLAB.  Run the v=daqvendorlist command.  Did that resolve your issue?  If the issue is not resolved, reply with a screen capture of your MATLAB's Add-On Manager.

Regards,

Fausto

[a.loconte2]

21 hours ago, Fausto said:

Hello @a.loconte2.

Please close MATLAB and install the current version of InstaCal.  Afterwards, connect your MCC USB-234 device to the target Windows system and launch InstaCal.  If the device is recognized by InstaCal, then close the application and launch MATLAB.  Run the v=daqvendorlist command.  Did that resolve your issue?  If the issue is not resolved, reply with a screen capture of your MATLAB's Add-On Manager.

Regards,

Fausto

No it didn't solve my issue. Here's the screen capture: