Protocol analyzer and Logic Analyzer simultaneously

I would really like to run the PA and the LA simultaneously. Here is an example of why: Every once in a while sniffing the I2c bus with the PA, I see "Error" and I'd like to look at the LA to see what the signals were actually doing at that point. I've seen one similar question where Atilla said that it would not be possible to trigger the LA on an error (too bad!) and another where someone else showed how to do the sniffing on either the LA or the PA. In addition, some of the documentation

Hi @BFisher The Protocol tool uses the Pattern Generator device resource to send, to drive the outputs, and Logic Analyzer device resource for reception, compressed data of significant bits for the respective protocol. These bits are further interpreted in the software. The errors could be caused by ringing or crosstalk between signals. Try enabling the 'Glitch filter' option, twist each signal wire separately with GND wire.