Hi, i followed a tutorial on a full adder, and everything works as expected, except for the 7 segment display. the project doesn't include it at all, but it dimly lights up after programming finishes. when loading the demo, the display works as expected, with segments fully off when they should be fully off. what may be happening? is this expected behaviour?
Thank you!
Edit to add: one of the DRC errors/warnings is about the configuration voltage and configuration bank voltage selection. I wonder if those two properties not being set might be what's causing this?
i checked the schematic and see CFGBVS_0 is connected to VCC3V3 with a 4.7k resistor in series. this doesn't make it clear if configuration bank voltage selection should be set to GND or VCCO, but i'm guessing configuration voltage is 3.3V?
Question
Anthocyanina
Hi, i followed a tutorial on a full adder, and everything works as expected, except for the 7 segment display. the project doesn't include it at all, but it dimly lights up after programming finishes. when loading the demo, the display works as expected, with segments fully off when they should be fully off. what may be happening? is this expected behaviour?
Thank you!
Edit to add: one of the DRC errors/warnings is about the configuration voltage and configuration bank voltage selection. I wonder if those two properties not being set might be what's causing this?
i checked the schematic and see CFGBVS_0 is connected to VCC3V3 with a 4.7k resistor in series. this doesn't make it clear if configuration bank voltage selection should be set to GND or VCCO, but i'm guessing configuration voltage is 3.3V?
Thanks!
Edited by AnthocyaninaLink to comment
Share on other sites
2 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now