I am working on a project where I am trying to run RTEMS on a Leon3 that exists on the Artix 7 FPGA on the Digilent Nexys A7 100t board. I have successfully programed the Leon3 bitfile from the GRLIB IP files to the board, and connected to it through GRMON.
I have also successfully compiled the RTEMS sources for the leon3 and tested it through TSIM to make sure it would load and run successfully, which it did.
However when trying to load and run the same .elf file, or any file, to the actual board through GRMON, nothing gets written to memory, even though the board reacts as though it is being programed. I have also tried manually writing data to memory, still with no luck.
I’m new to developing on the Nexys A7, and leon3 and with GRMON, so if anyone has any recommendations that would be greatly appreciated, thanks.
Question
Hamilton
I am working on a project where I am trying to run RTEMS on a Leon3 that exists on the Artix 7 FPGA on the Digilent Nexys A7 100t board. I have successfully programed the Leon3 bitfile from the GRLIB IP files to the board, and connected to it through GRMON.
I have also successfully compiled the RTEMS sources for the leon3 and tested it through TSIM to make sure it would load and run successfully, which it did.
However when trying to load and run the same .elf file, or any file, to the actual board through GRMON, nothing gets written to memory, even though the board reacts as though it is being programed. I have also tried manually writing data to memory, still with no luck.
I’m new to developing on the Nexys A7, and leon3 and with GRMON, so if anyone has any recommendations that would be greatly appreciated, thanks.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now