In Rpi-4 I have installed Adept and waveform software. Now I want to run Analog Discovery 2 in Network Analyzer mode from Rpi4 with these following specifications :
1. start frequency of 100 KHz
2. stop frequency at 1 MHz
3. no of point around 1 K. and few others.
Is this kind of control or operation is possible from RPi4 using SDK python ?
For Analog Discovery 2 and Raspberry pi 4 connection what kind of cable/wire I required ?
Question
RajatDas
I have a Analog Discovery 2 and Raspberry pi 4. For connection and package installation I am following this link "https://digilent.com/reference/test-and-measurement/guides/getting-started-with-raspberry-pi".
In Rpi-4 I have installed Adept and waveform software. Now I want to run Analog Discovery 2 in Network Analyzer mode from Rpi4 with these following specifications :
1. start frequency of 100 KHz
2. stop frequency at 1 MHz
3. no of point around 1 K. and few others.
Is this kind of control or operation is possible from RPi4 using SDK python ?
For Analog Discovery 2 and Raspberry pi 4 connection what kind of cable/wire I required ?
Link to comment
Share on other sites
13 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now