Programming Error on Artix-7 FPGA XC7A35T with Vivado Design Edition

[Cyr]

Dear Sir,


I am using an Artix-7 FPGA XC7A35T Vivado Design Edition purchased from DIGILENT. When I try to program the device I get following prompt,

refresh_hw_device [lindex [get_hw_devices] 0]
INFO: [Labtools 27-1434] Device xc7a35t (JTAG device index = 0) is programmed with a design that has no supported debug core(s) in it.
WARNING: [Labtools 27-3123] The debug hub core was not detected at User Scan Chain 1 or 3.



Please advise,

Kind Regards,
Cyr

[Sergiu]

Hello,

This issue was discussed before on the forum.

https://forum.digilentinc.com/search/?type=all&q=debug+hub

You can find the answer here.

Sergiu