Sarah01 Posted March 1, 2023 Share Posted March 1, 2023 (edited) Hello, After the slave and master for the PmodBT2 are connected to each other how do you communicate between them? Edited March 1, 2023 by Sarah01 Link to comment Share on other sites More sharing options...
0 artvvb Posted March 3, 2023 Share Posted March 3, 2023 Hi @Sarah01 Once the BT2 is connected to another device, the host board just uses the UART interface to send data back and forth, it reads incoming bytes and writes outgoing bytes. Bytes written to either Pmods' serial interface should just show up on the others'. Thanks, Arthur Link to comment Share on other sites More sharing options...
Question
Sarah01
Hello,
After the slave and master for the PmodBT2 are connected to each other how do you communicate between them?
Edited by Sarah01Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now