Analog Discovery 2 stopped working: communication failed
I had a Analog Discovery 2 which was working fine until it stopped being recognized by the Waveforms software. I was measuring an audio signal when it stopped working.
After plugging it in this message pops up in Waveforms (file attached)
Communication with the device failed
DeptIO failed ERC:2 out:8 in:28
Device status failed.
In Waveforms, after selecting the device (file attached) I get this pop up:
DeptIO failed ERC:2 out:8 in:8
Device configuration failed (PL
Hi attila,
thanks again for your feedback. I've run a couple of tests and and got something better.
I tried the AD2 with a 5V aux and both scope channels work, however I had to turn the power off quickly because the IC shown in the picture gets extremely hot. It seems to the ADA4051-2, right?
I cannot buy one of this in Brazil and have to order from some place in USA.
Do you think this should solve the problem? Is there any other component that could have been damaged?
Than