MCC DRV not in DASYLab

[Quinton]

When attempting to use DASYLab in conjunction with an MCC DAQ USB-1808, I am attempting to set up an analog input but the driver does not exist for MCC DRV in order to do so. I have performed instacal in order to detect the DAQ card and I have enabled "measurement computing" in the configurator. I am not sure where to go from here--I expected to be able to see the MCC DRV after enabling the package in the configurator.

[Fausto]

Hello @Quinton.

Which version of DASYLab are you using?

Do you have previous versions of DASYLab on the target system?

Which version of Windows are you using?

If you go back into the DASYLab Configurator, is the Measurement Computing package still enabled?

Regards,

Fausto

[Quinton]

Hi Fausto,

I am using DASYLab 2016. There was previously another version of DASYLab on the system but it has been removed.

I am using windows 10.

Measurement computing package is still enabled after restarted the system.

[Fausto]

Which version of InstaCal do you have installed?

Which version and build of DASYLab 2016 do you have installed?

In Windows' Control Panel - Programs and Features, click on 'Turn Windows features on or off' and verify that '.NET Framework 3.5' is enabled.

 

 

[Quinton]

I have "Instacal and universal library for windows" version 6.73.

DASYLab 2016 is version 14.2.0.882

.NET Framework 3.5 and 4.8 are both enables as shown in your screenshot.

[Fausto]

Try disabling the Measurement Computing package from the Configurator and then exit the Configurator.  Afterwards, go back into the Configurator and re-enable the Measurement Computing package.  Close the Configurator and open DASYLab.  Do you see the MCC-DRV branch?

[PeLe]

On 12/6/2022 at 11:15 PM, Fausto said:

Try disabling the Measurement Computing package from the Configurator and then exit the Configurator.  Afterwards, go back into the Configurator and re-enable the Measurement Computing package.  Close the Configurator and open DASYLab.  Do you see the MCC-DRV branch?

This was the solution after 2 hours being lost and without a clue why the MCC was not showing up. Thanks!