Excitation voltage 5V Channel 30 is applied to RED from encoder. Black is connected to a 240ohm resistor. Resistor is connected to GRND (Channel 3). Resistor also connects to Channel 1 for voltage input.
Channel mode is Single-Ended.
Voltage seen on Channel 1 is 0.76V. Encoder only increases the voltage up to 0.86V and then it stops. Is this a bad sensor? or is there something wrong with the wiring?
Question
chepox
I have a 2 wire encoder that outputs a 4-20mA.
Excitation voltage 5V Channel 30 is applied to RED from encoder. Black is connected to a 240ohm resistor. Resistor is connected to GRND (Channel 3). Resistor also connects to Channel 1 for voltage input.
Channel mode is Single-Ended.
Voltage seen on Channel 1 is 0.76V. Encoder only increases the voltage up to 0.86V and then it stops. Is this a bad sensor? or is there something wrong with the wiring?
Encoder is an CWP-S500A.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now