Schematic for openlogger?

[voltagesurge]

Hi all,

 

I was just wondering if there is any schematic of the layout of the openlogger. I'm currently using it for a research project and knowing its physical limitations would be helpful. I believe this was an open source project, so the files should be around somewhere but I've failed to find them :/

 

Any help would be much appreciated.

 

Sebastian

[JColvin]

Hi @voltagesurge,

I'm not certain if you are asking for the design files or just the schematic, but the schematic showing all of the pin connections is available on it's Resource Center under the Additional Resources section: https://digilent.com/reference/test-and-measurement/openlogger/start#additional_resources.

Let me know if you have any questions.

Thanks,
JColvin

[voltagesurge]

Hi JColvin, 

 

Thanks for getting back to me. I meant a schematic with the parts used etc. so I can find out what the design spec is. This should be useful in knowing what the accuracy is for the data-logger. I think this was released publicly as I believe I saw it once on this forum or something.

 

Regards

Sebastian

[JColvin]

Hi @voltagesurge,

I don't believe such material has ever been posted, at least as per this thread (which also applies to OpenLogger):

If you able to find the materials somewhere, I won't stop you from using them. Though it was my understanding that the schematic in the Resource Center does list the names of the all the components used so you can look up the datasheets for them. The only other thing I can think of was the Microchip Master Design Review slides that was done as a presentation for the OpenScope (available in it's Resource Center: https://digilent.com/reference/test-and-measurement/openscope-mz/start#additional_resources) but beyond that Digilent does not have anything further and despite me asking a number of times over the years, no further materials will be released for the OpenScope/Logger.

Thanks,
JColvin

[voltagesurge]

Hi JColvin, 

Thank you so much for replying. As far as I can tell, there are some schematics for the OpenScope which are helpful. I think those are the files that I referred to in my last message. Do you know if there is anything similar for the OpenLogger? Maybe I'm just missing something obvious, but I couldn't find anything similar for the OpenLogger on: https://digilent.com/reference/test-and-measurement/openlogger/start 

I appreciate your help, I don't think I'd have found those OpenScope schematics otherwise.

Regards

Sebastian