PLL_Geek Posted July 3, 2016 Share Posted July 3, 2016 I am using both channels of the scope and wavegen - two sine waves 180 degrees out of phase. Can I get a trigger out (square wave) from the wavegen that is synchronous with the sine wave? Link to comment Share on other sites More sharing options...
attila Posted July 4, 2016 Share Posted July 4, 2016 Hello, Since both AWG channels are busy, you can use the Digital IO from the Pattern generator to create a (0/3.3V) square wave. Set the AWG for Auto synchronized mode. Configure the Pattern to trigger on Wavegen 1 or 2, set Run time half of the awg frequency (use Wait time to phase shift the digital signal), add a constant signal to be low in idle and high while running. Link to comment Share on other sites More sharing options...
Question
PLL_Geek
I am using both channels of the scope and wavegen - two sine waves 180 degrees out of phase. Can I get a trigger out (square wave) from the wavegen that is synchronous with the sine wave?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.