The amplitude as measured when set to .1 Hz is 5.4V Hi and 0.0V Low using an external DMM and the AD2 'scope. When set to DC, the output measures 5.0V on the external DMM and the AD2 'scope. This error is small enough that it will not effect my usage (I'm simulating the turn signal output of my motorcycle), just wondering about the cause. Also, what is the maximum current output of the Wavegen?
Question
Dwayne
I have an error on the amplitude of a Wavegen squarewave with the following parameters:
1Hz, 5V Amplitude, 5V Offset, 50% Symmetry, 0 degrees Phase, CH1 output only.
The amplitude as measured when set to .1 Hz is 5.4V Hi and 0.0V Low using an external DMM and the AD2 'scope. When set to DC, the output measures 5.0V on the external DMM and the AD2 'scope. This error is small enough that it will not effect my usage (I'm simulating the turn signal output of my motorcycle), just wondering about the cause. Also, what is the maximum current output of the Wavegen?
Dwayne
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.