I was using JTAG HS2 programmer before but my PC upgraded from windows 10 to Windows 11. After that when I connect usb cable, i cant see anything in device manager (screenshot attached).
On clicking open target, I get following error
ERROR: [Labtools 27-2269] No devices detected on target localhost:3121/xilinx_tcf/Digilent/210251ADE638.
Check cable connectivity and that the target board is powered up then
use the disconnect_hw_server and connect_hw_server to re-register this hardware target.
ERROR: [Common 17-39] 'open_hw_target' failed due to earlier errors.
I have run install_drivers_wrapper.bat in \Vivado\2019.2\data\xicom\cable_drivers\nt64 but still same error.
I have changed USB cables also. But same issue.
Is it related to drivers? or something wrong with hardware? WHat should I see in hardware manager if HS2 is correctly connected
Question
a4speaker
I was using JTAG HS2 programmer before but my PC upgraded from windows 10 to Windows 11. After that when I connect usb cable, i cant see anything in device manager (screenshot attached).
On clicking open target, I get following error
ERROR: [Labtools 27-2269] No devices detected on target localhost:3121/xilinx_tcf/Digilent/210251ADE638.
Check cable connectivity and that the target board is powered up then
use the disconnect_hw_server and connect_hw_server to re-register this hardware target.
ERROR: [Common 17-39] 'open_hw_target' failed due to earlier errors.
I have run install_drivers_wrapper.bat in \Vivado\2019.2\data\xicom\cable_drivers\nt64 but still same error.
I have changed USB cables also. But same issue.
Is it related to drivers? or something wrong with hardware? WHat should I see in hardware manager if HS2 is correctly connected
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now