I had a question on the mipi_csi2_rx_subsystem IP core. I am currently using mipi_csi2_rx_subsyst IP core v4.0 in the design. Which properties shall I use for the Block Properties settings to be Zedboard compatible using the Digilent PCAM FMC adapter. The by default design is set for ZCU102 board.
CONFIG.C_EXDES_BOARD ZCU102
CONFIG.C_EXDES_CONFIG MIPI_Video_Pipe_Camera_to_Display
CONFIG.C_EXDES_FMC LI-IMX274MIPI-FMC V1.0 Single Sensor
Question
iyer25
I had a question on the mipi_csi2_rx_subsystem IP core. I am currently using mipi_csi2_rx_subsyst IP core v4.0 in the design. Which properties shall I use for the Block Properties settings to be Zedboard compatible using the Digilent PCAM FMC adapter. The by default design is set for ZCU102 board.
CONFIG.C_EXDES_BOARD ZCU102
CONFIG.C_EXDES_CONFIG MIPI_Video_Pipe_Camera_to_Display
CONFIG.C_EXDES_FMC LI-IMX274MIPI-FMC V1.0 Single Sensor
https://china.xilinx.com/support/documentation/pgi-pg .
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.