I designed an breakout board with SYZYGY connector. After I added 3.3V and 5V external power supply on SYZYGY connector, and removed them, the Eclypse Z7 board cannot connect to Vivado normally now. Actually, when I connected the board to PC, there was no USB device detected. All the outputs of voltage regulator on Eclypse Z7 board are tested normal. Could you please give me some suggestions that which part on board might be affected?
Question
Charlie.Li
Hi all,
I designed an breakout board with SYZYGY connector. After I added 3.3V and 5V external power supply on SYZYGY connector, and removed them, the Eclypse Z7 board cannot connect to Vivado normally now. Actually, when I connected the board to PC, there was no USB device detected. All the outputs of voltage regulator on Eclypse Z7 board are tested normal. Could you please give me some suggestions that which part on board might be affected?
Thanks.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.