UC_J Posted October 7, 2020 Share Posted October 7, 2020 Hello Everyone, I have an OpenScope MZ and the channel 1 power supply stays on and will not adjust from the value in the picture. I have re-flashed the firmware. Calibration attempts have all failed, I suspect that this is because the Voltage is too high to be adjusted. Does anyone know a fix for this? Thanks in advance, J Link to comment Share on other sites More sharing options...
UC_J Posted October 7, 2020 Author Share Posted October 7, 2020 To add more background to this. I work for University of Cincinnati. My department purchased 100 of these devices to facilitate teaching electronics lab online. This is the first semester they are in use. We have had no problems so far. This past week the students used the dual power supply for the first time this past week and now I have two units out of about 88 that have this same problem. The second unit is stuck at around 1 Volt. I have searched the forms and reviewed the content that Digilent has made available. J Link to comment Share on other sites More sharing options...
JColvin Posted October 22, 2020 Share Posted October 22, 2020 Hi @UC_J, I apologize for the delay. I asked some other engineers about this but we don't have any additional suggestions beyond what you have already tried. I will send you a PM to discuss replacement options. Thanks, JColvin Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now