Jump to content

Looking for example or tutorial on using Ethernet port on Cora Z10


Recommended Posts

My goal is to replace an embedded processor and interface logic for controlling an AD9959 DDS chip.

I would like to enter data through a TCP/IP Ethernet link. There is a control computer that communicates with the controller with a LabVIEW interface. The function of the PS would be to load and read memory registers, possibly with some calculations in C. The PL would generate the control signals for the DDS. In addition the PL will implement an 8 channel pulse generator with individually programmable time delays and pulse widths. I think I know how to do the pulse generator if I can get the data into registers from Ethernet data.

 Any pointers to examples or suggestions about how to proceed would be greatly appreciated.


Thanks, Jim

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...