Kris Persyn Posted April 25, 2019 Share Posted April 25, 2019 Hi, I'm stuck in SDK. I want to control visuals by manipulating an hdmi out design, but can't seem to get my software to run properly. I cant even xil_printf nor light some LEDs on my Zybo z20. Any suggestions? head.h helloworld.c Link to comment Share on other sites More sharing options...
vicentiu Posted April 25, 2019 Share Posted April 25, 2019 Are you doing this on Linux or bare metal? Link to comment Share on other sites More sharing options...
Kris Persyn Posted April 28, 2019 Author Share Posted April 28, 2019 @vicentiu I'm using the Zynq-7000 AP SoC.. Link to comment Share on other sites More sharing options...
vicentiu Posted April 28, 2019 Share Posted April 28, 2019 Are you running your helloworld.c directly on zynq (bare metal), or on Linux? From your description, it seems like you're running on bare metal, but you posted in the Linux section of the forum. I'm trying to determine if you posted in the right place. Link to comment Share on other sites More sharing options...
Kris Persyn Posted April 28, 2019 Author Share Posted April 28, 2019 @vicentiu My bad! Link to comment Share on other sites More sharing options...
Question
Kris Persyn
Hi,
I'm stuck in SDK. I want to control visuals by manipulating an hdmi out design, but can't seem to get my software to run properly. I cant even xil_printf nor light some LEDs on my Zybo z20. Any suggestions?
head.h helloworld.c
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.