WhenI pluggedthe micro usb cable on the J4 connector (usb configuration is set as power source from J2 connector) ant I active the switch power on , the board remains off (power led is off).
The basys 3 has already worked (from vivado it was possible to open the hw and program the FPGA) in the past but now I have this issue.
Question
jpmfoot
hello,
When I plugged the micro usb cable on the J4 connector (usb configuration is set as power source from J2 connector) ant I active the switch power on , the board remains off (power led is off).
The basys 3 has already worked (from vivado it was possible to open the hw and program the FPGA) in the past but now I have this issue.
Thanks for your help.
jpmfoot
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.