arlene703 Posted February 18, 2019 Share Posted February 18, 2019 Hello, I have been following the OpenScope MZ tutorials and got stuck at the Instrument Panel video because I have been unable to successfully generate a sine wave using waveformslive. I was unable to generate the sine wave using the 'single' option on the panel, it remains stuck in the armed status. The only signal that I have been able to generate (pictured below) is too noisy and had to use the force option on the panel. I've re-calibrated several times, tried it on different internet browsers, and have tried running the device using the network and USB option. Thank you, Arlene Link to comment Share on other sites More sharing options...
JColvin Posted February 18, 2019 Share Posted February 18, 2019 Hi @arlene703, Could you attach a picture of your physical setup? The only thing I was able to find that closely replicated your setup was that the WaveForm generator (yellow wire) was connected to Oscilloscope channel 2 (the blue wire) rather than Oscilloscope channel 1 (orange wire). Let me know if you have any more questions. Thanks, JColvin Link to comment Share on other sites More sharing options...
arlene703 Posted February 19, 2019 Author Share Posted February 19, 2019 That solved my issue, thank you so much. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.