I using a this tutorial http://www.instructables.com/id/Setting-up-the-Zybot-Software/ boot a Linaro on zybo board. Everything works normally, HDMI and boot Linaro. When i create a my own BOOT.bin using a system_wrapper.bit and FSBL.elf from zybo_base_system downloaded from digilent site and following the digilent tutorial to create a u-boot.elf. Linaro is booting, but the HDMI is not working. I attached the booting logs with HDMI and without HDMI. I think that the VDMA driver is not loading with my BOOT.bin. Please a help with my problem.
Question
asd
Hi,
I using a this tutorial http://www.instructables.com/id/Setting-up-the-Zybot-Software/ boot a Linaro on zybo board. Everything works normally, HDMI and boot Linaro. When i create a my own BOOT.bin using a system_wrapper.bit and FSBL.elf from zybo_base_system downloaded from digilent site and following the digilent tutorial to create a u-boot.elf. Linaro is booting, but the HDMI is not working. I attached the booting logs with HDMI and without HDMI. I think that the VDMA driver is not loading with my BOOT.bin. Please a help with my problem.
Best Regards,
Maciek
no_HDMI.log
with_HDMI.log
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.