I need help to initialise and implement an inout port in BASYS 2(Spartan 3E) FPGA board. I tried using IOBUF and assigned that port to B6 or A9 or C6.I couldn't get the result. Without using the IOBUF, i am getting the desired signal pattern as output but in milli volt range. And i'm not sure whether i able to recive or not with out using the IOBUF since I could not test it..
I want to implement the I2C protocol, so the sda line should be INOUT, which I cant figure out...Should I use any specific PIn in Pmods of Basys 2 as Inout port.... Please help me with this...
Question
athulbalanea
Hi,
I need help to initialise and implement an inout port in BASYS 2(Spartan 3E) FPGA board. I tried using IOBUF and assigned that port to B6 or A9 or C6.I couldn't get the result. Without using the IOBUF, i am getting the desired signal pattern as output but in milli volt range. And i'm not sure whether i able to recive or not with out using the IOBUF since I could not test it..
I want to implement the I2C protocol, so the sda line should be INOUT, which I cant figure out...Should I use any specific PIn in Pmods of Basys 2 as Inout port.... Please help me with this...
Thanks in Advance
Athul
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.