bit2gb

My sd is clear, i do not have any file on them. Is necesary to put some date on sd card? If yes what data?

Here is my project (all files): https://www85.zippyshare.com/v/2Wt6ARkJ/file.html

i change my diagram but i recive same error with faild mount driver 0 Gateway IP: 192.168.43.1 Subnet mask: 255.255.255.0 Dns 0: IP: 192.168.43.1 Dns 1: IP: 8.8.8.8 Dns 2: IP: 8.8.4.4 Dns 3: IP: 8.8.8.8 My MAC: 0:30:192:16:194:60 5 Sockets Listening on IP: 192.168.43.73: 80 Listening Sockets = 5 Listening Sockets = 4 Got a client: 0x80065D28 New Client detected Default page called Read an HTML page off of the SD card Entering Client ID: 0x80065D28 GET / HTTP/1.1 SD FileName: HomePage.htmHttpServer Work :xFailed to mount drive 0: Error: 13Start WiFi Scan Scan Done, 26 Networks Found

Well right now i program board and when i run sdk i recive in terminal i all data, bord are connected to wifi, but when i want to go on the ip indicate i recive this: My IP: 192.168.0.103 Gateway IP: 192.168.0.1 Subnet mask: 255.255.255.0 Dns 0: IP: 192.168.0.1 Dns 1: IP: 8.8.8.8 Dns 2: IP: 8.8.4.4 Dns 3: IP: 8.8.8.8 My MAC: 0:30:192:16:194:60 5 Sockets Listening on IP: 192.168.0.103: 80 Listening Sockets = 5 Got a client: 0x80065AF8 New Client detected Got a client: 0x80065D24 New Client detected Default page called Read an HTML page off of the SD card Entering Client ID: 0x80065AF8 GET / HTTP/1.1 SD FileName: HomePage.htmIOServer v1.0 Copyright 2015, Digilent Inc. Written by Keith Vogel Failed to mount drive 0: Error: 3Start WiFi Scan And page is not loaded. I mention i not use GPIO (i do not use leds/sw or other stuff) Problem is from mount driver 0 i think! Is necesary to have an SD card reader ?? Without sd card module this tutorial is not possible? In diagram i use an jc conector for sd card but i have on my board nexys4 ddr, in this case how bloc is necesary to use?

Ok, now i create bitstream but after i export hardware and launch SDK there don't have PmodWIFi folder for continue with http server config. How shoul i do

Hello, I follow this tutorial But seems the MIG block after adding the ddr2 didnt contain the reference clock input, there only system clock which was connected, will this still affect the design and i recive an error for clk freqence. Please help me! Thx