Hi,
I recently ordered an MCC DAQ device.
I have installed the needed software and calibrated using instacal.
However, when I run a test using a thermocouple, I get a voltage output of 0.0049V and -0.0049V from one analogue input channel.
When I place the thermocouple in hot water, I get the same voltage outputs which should not be right.
I have used different thermocouples and the result is the same.
I use DAQami and differential channel input.
Single channels give different voltages but the problem still persists.
I have attached an excel file.
Thanks
Analog - 21-08-2024 11-43-10.9342.csv