Hi, my first time using my AD3 out of the box and using it as a 5V power supply I was getting readings of only 0.2V across a resistor. I was using a USB to USBC cable plugged into the wall, so I then tried plugging the cable into a computer, then using a shorter cable. I have an old USB chord with the end chopped off and leads soldered to the hot/ground wires that I've used previously to supply 5V, and when I switched to that I was getting the correct readings, so it wasn't a problem with my board or components.
The last thing I tried was ordering an auxiliary power supply, which was 5V and 4A, which was what the guide specified. The problem persisted after this, which showed that it isn't a problem with USB conversion, my computer, or anything else.
Is there anything else to try at this point, or is there something wrong with my AD3?