Evan Cleary

Hi @JColvin when we last spole I was using a NI Virtual bench with the LabView Virtual Bench library. We have now recieved an ADP 5250 and I am trying to get this to work with the same library, the Virtual Bench library uses a VirtualBench Device I/O Control, this unfortunately isnt finding the 5250, I can see the 5250 in waveforms though Is there a way to get the labview control to see the 5250?

Hello again @JColvin apologies for not getting back sooner, yer it works fine without issues got an api based around the library finished and fully tested today without issues thank you very much for your help

Hi @JColvin, thank you very much for your response I am going to be using 2021 SP1, I have followed the instructions given in the following links, which i followed from the link you shared https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000kJXaSAM&_ga=2.14947382.1217338680.1712253343-151680061.1710960077&l=sv-SE https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000kJXVSA2&l=sv-SE I installed VirtualBench 19 first. It seems to have worked, in function pallet, etc. I cant verify right now but ill know better in the morning I have noticed however that I get a broken wire in the dmm vis but no broken arrow, any idea what this is about? Its a new one to me

Hi, I am creating a LabView application needs to access the DMM and all DMM functionality such as measuring voltage, resistance, continuity, etc, for the ADP5250 and NI Virtual Bench The Diligent waveforms library for LabView does not include VIs to control the DMM I have also looked through the SDK reference manual and there is no mention of how to address the DMM and access functions, it does however reference the DMM as channel 3 on the device page for the 5250 The Waveforms application recognizes the Virtual Bench as the same type of device as the ADP5250 and it allows the user to control the DMM so there must be a way to access it. If some kind soul could help me to figure out how to use the DMM in Labview or how to write C or python code that can be called by LabView then it would be greatly appreciated. Thanks in advance 🙂