JEON

hello I am testing the DasyLab program today by installing it, looking at the manual and connecting sensors. But I was wondering how to zeroing sensor, as there doesn't seem to be a way to do so in the manual. I purchased USB-2404-UI fand DASYLab Basics. I want to use the telemetry system to measure torque with strain gauge full bridge on the ship shaft. The telemetry system converts the strain gauge signal into wireless RF waves and receives 0~10V output from the USB-2404-UI and calibrates it to measure the ship's shaft horsepower using the measured torque and RPM value. I need to initially zero and calibrate the 0~10V value of the telemetry system, and I was wondering if there is a way to do it. Telemetry system datasheet is attached. Any help would be appreciated. Technical Data 1ch Telemetry System SG TC Auto Zero.pdf

hello I am testing the DasyLab program today by installing it, looking at the manual and connecting sensors. But I was wondering how to zeroing sensor, as there doesn't seem to be a way to do so in the manual. Any help would be appreciated. Thank you.