KatharinaSt

Hi @JColvin, when I use the following settings: ..., which is the correct waveform, cause I want a break between the pulses, I get the following result: The pulse above is my trigger and the one below is the result of my wavegenerator. It gives me only one biphasic pulse, but I want the waveform as above (several biphasic pulses with a short break inbetween. This wave should run for 2 sec and should then stop and wait for the next rising edge. If I choose the following settings: ... I get the correct duration of the biphasic pulses, but not the breaks between the pulses: Is there a possibility to get the waveform from the second picture for 2 seconds in a row ? BR, Katharina

HI @JColvin, I started the wavegen instrument so that it could arm, but there is no signal showing up. My input at the trigger 1 is a analog input pulse from another device, which changes between 0 and 1 (1sec high, 4sec low). Now, the wavegenerator 1 should trigger according the rising edge of the trigger 1, but there is no signal showing up, when I connect an oscilloscope at the wavegenerator 1. But I don't know why... Thank, Katharina

@JColvin I tried to trigger according your instruction but it is not working...

Thank you very much for the answer. One other question: Is there a possibility to start the waveform at the rising edge of the trigger and to stop at the falling edge? BR, Katharina

Hi guys, I am using the analog discovery 2 and I want to generate a triggered Waveform. Additionally I am using the Software Waveforms. Is there a possibility to trigger the waveform generator of the analog discovery with an external trigger within the Software Waveforms? If not, is it possible with the pydwf package in Python? If yes, can you provide me with some example code? Additionally I wanted to ask if it is possible to generate a biphasic square waveform with the analog discovery 2? BR, Katharina