Airmanblu

Apologies for the lateness, but for some reason I'm not getting updates. Either way, since the original post I spoke with Digilent tech services and was sent 3 more devices after going through the troubleshooting process twice and sending a video of the operations. However, it ended with the same result. I've previously jumpered JP1 with no change, I do not believe on the new units I tried this. I will try to get to it this weekend. I am not optimistic that the JP1 jumper which is meant for multiple devices being "tethered" together and is normally left without a jumper attached on most other posts I've seen during the span of attempting to get the myRIO to complete its' communication with the PMOD CLS.

From the manufacturer the slave select is open which is what the SPI interface tutorial from NI shows. In essence there should be no jumper attached to JP1. There is no slave device, its a singular PMOD CLS. Attached is the connection from the myRIO to the PMOD. The only lines connected are J1 pins 2, 4, 5, and 6.

Good evening, I have been struggling with a lab for school. The lab is using the SPI vi in LabVIEW to connect to the myRIO to the PMOD CLS LCD in order to display stings. This device has worked well for the I2C, TWI, and UART communication protocols. However, for some reason when using the SPI for write operations, it will not output and no combination of the MO jumper locations will result in an output. Per the reference manual, the only jumper needed is on MO0 as the board is a rev. E. I purchased the first CLS through Studica in the embedded systems kit, when that one failed I went though Mouser to purchase another. (I currently live in Germany) So far neither device seems to work. The interface is via the MOSI and SCLK pins, with 3.3v and ground from the myRIO. The LabVIEW version used is LabVIEW myRIO Toolkit 2019. The myRIO is a 1900 and was purchased in 2020. This is the vi that is being used. Any advice would be greatly appreciated.