Caleb Young

Hey @JColvin, Good to know about the V-, thank you. The Scope Channel 1 was grounded in error, I moved that channel around during troubleshooting and landed it incorrectly by a pin. I was connecting V+ to the red + rails on the breadboard. Thanks for your help, I will disconnect the ground from V -

Hey @JColvin, Version 3.20.1 for Waveforms. I definitely have not grounded V+, but did ground V-. Picture below, and I did have V+ connected to the top leftmost pin when I started seeing the error. If I remove the ground from, V- I no longer see the error, but I could have sworn I have built and used circuits by connecting V+ to my Vdd pins and V- to ground before.. With the photo exactly as is I am getting the error. I use it over USB but I have ordered my own 5V power supply as a backup. Thanks for the help!

I was troubleshooting a circuit I built for my lab class and am using Analog Digital Discovery 2 with Waveforms. I was not getting my expected output. I measured the voltage from V+ which I had set to 5V and was getting 0. This is the error I am getting when I try to enable the power supply, but I am getting it even with nothing connected to V+ and V- connected to ground. I disconnected all other inputs other than the ground connection but still got the same error. I have used this for my past labs without any issue using the same USB connection to my PC and the same setup, V+ to the + on the breadboard, V- to the negative on the breadboard. If there is nothing connected to V+, I am unsure how I am getting an overcurrent condition. Do you have any ideas or troubleshooting tips?