JaredB

Thank you for your advice JRys, I added a scaling module in DASYLab and set the scaling at 33,266.799 (For a 500lb load cell with a sensitivity of 1.052mv/V). When I start the data collection, the digital meter coming off the scaling module reads "###". However, if I enter a scaling factor of 10,000 I see a value of 78.12499 in the digital meter, which just reflects the positive 7.8mV/V range value I set in InstaCal multiplied by 10,000 and the value still does not change with an applied load. Any suggestions?

Hello, I am working on setting up two single axis loadcells from FUTEK (Model #: LCF456) with the USB-2404-UI DAQ in DASYLab. I have installed InstaCal, and have successfully added the USB-2404-UI Board, configuring CH 0 and CH 1 as follows: Channel Mode: Bridge Bridge Type: Full Bridge Range: +/- 62.5 mV/V However, I do not see an option in InstaCal to input the load cells' calibration data (i.e. Rated Output, Linearity, etc.), are these inputs set somewhere in DASYLab? In DASYLab, I have added an Analog Input module (Inputs/Outputs >> MCC-DRV >> Analog Input) and set all the available options as desired. However, I do not see an option within the Analog Input window to set the excitation voltage for the load cells, is this handled through a different module? After adding a Digital Meter display and running the data collection, I do not see any change in the digital meter value with an applied load on the load cells, any suggestions?