[Connection from a block external port to the Arty S7 schematic]

Hi,  While creating a MicroBlaze block, it became necessary to supply the reset signal from the Arty S7 to the resetn pin of the Clocking Wizard.  I believe this was accomplished successfully.  However, how do I know that the port signal name "reset" is actually connected to the  Arty S7 schematic net "CK_RST"  ?

Thanks

oldViking

[What VHDL code is needed to operate the XADC after configuring the wizard]

Hi, 

I am trying to operate the XADC on my Arty S7.  I think I have the wizard set up to operate in a continuous mode.

When the wizard is open, it shows a pinout of the module.  Two of the inputs are the dclk_in, and the reset_in.

Is it my responsibility to add VHDL code that will connect these pins to the correct signal ?

If so do you have some sample VHDL code that will provide some guidance ?  I have no idea where to get a reset signal from.

As a first step, before looking at conversion data, I would be satisfied to see the output signal eoc_out changing states in a predictable manner (on my scope).

Thank you

oldViking

[My Arty S7 FPGA development board]

Hi, I went into the device manager, USB controllers on my win11 machine.   After having plugged the Arty S7 into my USB  port, there does not appear to be any presence of a Digilent device.

I have tried this on two different USB ports, using two different USB cables.

Thank you

oldViking

[My Arty S7 FPGA development board]

Last week I connected my Arty S7 development board to the USB port on my laptop.   It appears to be completely dead because none of the normal LED activity appeared.  I have tried 2 other USB ports on the laptop with the same result.

Where should I go from here ?

Thanks

oldViking