[Zedboard is not detected in windows 10 64-bit]

On 3/22/2023 at 4:02 AM, JColvin said:

Hi @eduemon,

To check what is on the SD card you can simply view its contents on a computer.

The other questions that I have regarding your setup are:

- What revision of the Zedboard do you have?
- How are the 5 MIO jumpers arranged?
- When you attempted to reconfigure the Zedboard, which microUSB port did you connect to? The J17 port labeled PROG should be the one to use.

Otherwise, I would recommend taking a look at this thread where I've gathered some resources for connecting to the Zedboard in case you haven't seen it.

Thanks,
JColvin

- What revision of the Zedboard do you have?
Rev. D
- How are the 5 MIO jumpers arranged?
MIO2 (JP7) - GND
MIO3 (JP8) - GND
MIO4 (JP9) - 3.3V
MIO5 (JP10) - 3.3V
MIO6 (JP11) - GND
- When you attempted to reconfigure the Zedboard, which microUSB port did you connect to? The J17 port labeled PROG should be the one to use.
I used J14 usb port as mentioned in Getting Started Instructions sheet from Zedboard box. 

I have seen the post that you mention. I think my problem with serial driver is done. It is based on the indication I got from CyUSBUart application. (screenshot attached) But It did not give any response.

Best regards,
Edwar

[Zedboard is not detected in windows 10 64-bit]

Dear all,

This is the first time I am working with Zedboard for my research. I got a problem in the very beginning step. I was trying to connect my zedboard with my laptop. My zedboard already has SDCard which I believe the OS has been installed there ( but I do not know how to check it). Then I connected my zedboard with my laptop. LD13 is ON, then. According to zedboard getting started instructions, I just need to wait for about 15 seconds to see LD12 is ON and the OLED is ON as well. However, both of them were still OFF after I wait for minutes. Then, I installed the cypress USB driver, turned the board OFF and ON again, but the result was still the same. I also tried to check the zedboard response through TerraTerm, and I found no response from zedboard. Do you have any idea what is going wrong with my zedboard?

Thank you very much.