Jump to content

eduemon

Members
  • Posts

    2
  • Joined

  • Last visited

Everything posted by eduemon

  1. - What revision of the Zedboard do you have? Rev. D - How are the 5 MIO jumpers arranged? MIO2 (JP7) - GND MIO3 (JP8) - GND MIO4 (JP9) - 3.3V MIO5 (JP10) - 3.3V MIO6 (JP11) - GND - When you attempted to reconfigure the Zedboard, which microUSB port did you connect to? The J17 port labeled PROG should be the one to use. I used J14 usb port as mentioned in Getting Started Instructions sheet from Zedboard box. I have seen the post that you mention. I think my problem with serial driver is done. It is based on the indication I got from CyUSBUart application. (screenshot attached) But It did not give any response. Best regards, Edwar
  2. Dear all, This is the first time I am working with Zedboard for my research. I got a problem in the very beginning step. I was trying to connect my zedboard with my laptop. My zedboard already has SDCard which I believe the OS has been installed there ( but I do not know how to check it). Then I connected my zedboard with my laptop. LD13 is ON, then. According to zedboard getting started instructions, I just need to wait for about 15 seconds to see LD12 is ON and the OLED is ON as well. However, both of them were still OFF after I wait for minutes. Then, I installed the cypress USB driver, turned the board OFF and ON again, but the result was still the same. I also tried to check the zedboard response through TerraTerm, and I found no response from zedboard. Do you have any idea what is going wrong with my zedboard? Thank you very much.
×
×
  • Create New...