Dear all,
This is the first time I am working with Zedboard for my research. I got a problem in the very beginning step. I was trying to connect my zedboard with my laptop. My zedboard already has SDCard which I believe the OS has been installed there ( but I do not know how to check it). Then I connected my zedboard with my laptop. LD13 is ON, then. According to zedboard getting started instructions, I just need to wait for about 15 seconds to see LD12 is ON and the OLED is ON as well. However, both of them were still OFF after I wait for minutes. Then, I installed the cypress USB driver, turned the board OFF and ON again, but the result was still the same. I also tried to check the zedboard response through TerraTerm, and I found no response from zedboard. Do you have any idea what is going wrong with my zedboard?
Thank you very much.