PJAB

Hi, The main issue I have is currently the Zedboard doesn't even boot up and the power LED doesn'/t turn on. Instead when I connect the power adapter, all 8 of the LEDs turn on. I was using this tutorial I found: https://www.hackster.io/adam-taylor/signal-processing-with-xadc-and-pynq-3c716c. Using the same IPs but different board file, basically just following the general structure. After programming the Zedboard everything was fine, and I connected the V_n and V_p inputs (pins 1 & 2 ) to a analog signal generator, which as set to 0.5v. The next parts however are quite hazy for me because it was in the spur of the moment, I think I pressed the PS-RST button and suddenly all the LEDs turned on or before I pressed it it was already like that. And since then it's been stuck in that way and unusable at the moment. I've found a similar post on this forum relating to the same issue and followed it, however as I'm just a student I'm lost on the next steps. I have found that the IN4- < IN4+ for the IC29, and in turn traced it to IC27 where the C340 is around 0V. However from here I'm not sure what steps I need to perform in order to fix this. Below I have referenced the 2 forum entries I have read through and tried to follow. I apologize in advance if my explanation of my situation isn't clear enough, please let me know if there are more details I should provide. https://community.element14.com/products/devtools/avnetboardscommunity/avnetboard-forums/f/general/36514/zedboard-leds-on-power-up-board-not-booting Thank you for taking the time to help me.