Hi John
thanks very much for your reply. We have instacal installed and we ran this registry update (we can see the board in instacal - however we keep getting this warning to run a registry update each time we log in and connect the minilab).
I am attempting to use matlab v 2022 to write digital output lines to control some lights.
However when I use the DAQ toolbox functions in matlab the minilab only shows up as being an 'analogue' device (see below).
As such I am unable to add digital output lines which is what I need to do.
Any ideas on what might be happening here?
best
Fraser
m1=daqlist("mcc");
>> m1.DeviceInfo
ans =
mcc: Measurement Computing Corp. miniLAB 1008 (Device ID: 'Board0')
Analog input supports:
8 ranges supported
Rates from 100.0 to 1200.0 scans/sec
8 channels ('Ai0' - 'Ai7')
'Voltage' measurement type
Analog output supports:
0 to +5.0 Volts range
2 channels ('Ao0','Ao1')
'Voltage' measurement type