[Analog Discovery 2 not recognized on my M1 Mac 12.0.1 device tree]

@malexander

I've been off the project for a while, I just noticed your message now. Thank you for offering to help.

On 12/9/2021 at 10:50 PM, malexander said:

Just to confirm, have you tried connecting the AD2 directly to your 2020 M1 MacBook Pro without the hub to see if that makes any difference?

No, I haven't. I only have a USB-A cable from my AD2, so I need the hub in order to connect it to the USB-C ports of my MacBook. I just googled, but haven't seen any Micro-USB to USB-C cables to connect the AD2 to my MacBook directly. Is this a thing?

On 12/9/2021 at 10:50 PM, malexander said:

Can you provide the full part number for the UGREEN USB-C hub? I don't have a M1 MacBook Pro but I do have a 2021 M1 MacMini that I could try to replicate this with.

That would be great! There is no part number on my USB-C hub unfortunately, but here is the link to the component:
https://www.ugreen.com/products/6-in-1-usb-c-pd-adapter-with-4k-hdmi

Any help would be greatly appreciated.

Best wishes,
Roland

[Analog Discovery 2 not recognized on my M1 Mac 12.0.1 device tree]

@attila, thanks for the reply.

On 12/2/2021 at 11:56 AM, attila said:

Is the device detected/working with other computers?

Yes, it is. I have tested the completely same setup (same USB-C hub, same cables) on my colleagues' laptop, which runs Windows 10. The device got recognized in Windows' Device Manager without a problem. I did not check any further (install drivers etc.), because that did not seem necessary to me yet. Knowing that Windows is able to recognize the device led me to believe that it is not the fault of my hardware setup.

[Analog Discovery 2 not recognized on my M1 Mac 12.0.1 device tree]

Dear Community,

I have connectivity troubles with my Analog Discovery 2 board. I am using a 2020 M1 MacBook Pro with MacOS 12.0.1 Monterey, and a UGREEN USB-C hub for the physical connection. My problem is that although my machine recognizes the USB hub, I do not see the AD2 board in the device tree at all. I have attached screenshots of my device tree without the hub and with the hub. If I connect the AD2 to the hub, my device tree does not change upon reloading. I've tried all kinds of esoteric combinations of restarting the machine with/without the AD2 connected, and I'm kind of at a loss. Any help would be greatly appreciated!