eljuli

thanks again, it worked!!

thanks for the answer and your great support. I'll try and proof my soldering skills...

Hello, thanks for reply. i'll try to explain a bit. I soldered some pins to the board(I know this is not the purpose of this board but this is what I have) to program an external fpga board. the problem is the pad for the 3.3v pin was tear apart so now I don't have a pad to solder a pin and power the board. see attached: I have vdd pad intact so I guess I can use this pin to feed the 3.3v but if not I can manage to use an extra 3.3v source... Regards, Julian

Hi I have this programmer and broke the 3.3v terminal pin so i'm not able to power the board. unless i can solder somewhere a wire to power the board from vref signal that is the same voltage... but there is not schematics so can't solve it without your help. Where should I find a place or info to solve this problem?. just need to know a place where to feed the 3.3v not the whole schematics. Thanks, regards.