[DstmTransfer failed ERC: 3077 over ethernet]

I also have been getting a slightly different error message sometimes:

DstmTransfer failed ERC: 3077
Device configuration failed ().
Config 1
Config 1
Device configuration failed ().
Data write

 

[DstmTransfer failed ERC: 3077 over ethernet]

Hi @attila,

 

It's still not working when trying to connect with Ethernet Standard. I'm also getting the error intermittently when connected in Ethernet Linux, very infrequent though.

The IP is obtained through DHCP, I have tried both manual and DHCP. I have also tried other external ethernet adapters on the host to see if the error was due to host to interface communication. Looking at the traffic with Wireshark the communication seems to be working. I see UDP packages where it seems that the ADP is announcing itself, and I can see TCP communication between the host and the ADP when trying to connect.

[DstmTransfer failed ERC: 3077 over ethernet]

Booting into Standard mode gives this terminal output:

AXI-DMA Setup

Boot v03.3E
MultiBoot: 0x0000C000
RebootStatus: 0x00480000
ResetReason: 0x00

Press any key for Recovery Mode...
S for Standard Mode
L for Linux Mode

PL done
QSPI: 01-20-18-4D-01-80
Programming PL
DDR Check
BootMode 0x01
Loading Standard Mode
PH 0 from: 0x044000 [8] to: 0x134000 [8]
PH 1 from: 0x010000 [34010] to: 0x100000 [34010]
FsblHandoffExit

Running Standard Mode v03.3E
PL done
QSPI: 01-20-18-4D-01-80
AXI-DMA Setup
Setup
MAC: 00-18-3E-03-94-ED
Running
USB Connect 1
Start PHY autonegotiation 
Waiting for PHY to complete autonegotiation.
autonegotiation complete 
link speed for phy address 15: 1000
IP :       192.168.86.249
Netmask :  255.255.255.0
Gateway :  192.168.86.1

There's no additional output when trying to connect.

[DstmTransfer failed ERC: 3077 over ethernet]

Thank for your quick reply @JColvin.

• I get the error for Ethernet Standard. Ethernet Linux mode did not work, but is now working. I do not know if it's because of me upgrading to the latest WaveForms or switching modes back and forth. 
• Everything has been working flawlessly until yesterday in both Ethernet/USB Standard mode and Ethernet/USB Linux mode.
• The host computer and the ADP3450 are connected through a switch without any NAT or firewall.
• I got this error at the start of a working session. It worked the day before and there were no changes to the hardware setup, changes of modes.

Is there any additional logs and/or debug flags I can enable?

Thank you.

 

[DstmTransfer failed ERC: 3077 over ethernet]

Hi,

I suddenly can't connect to my ADP3450 over ethernet. I have tried the stable version of WaveForms as well as beta 3.16.34.

I'm getting the error message:

DstmTransfer failed ERC: 3077
Device configuration failed (PLL).
/Applications/WaveForms.app/Contents/Frameworks/dwf.framework/Resources/digilent/waveforms/firmware/DCFG_06_04_01.bit

I'm on Mac OS X 11.5.2

I have tried a standard failsafe recovery boot, upgrading the firmware but no success. USB Standard works.

Please advice on what to do. Thank you.