[PMOD AD1 instantiation code]

Hello, I am using Pmod AD1 for simultaneous signal conversion from 2 photomultiplier tubes. I followed all the steps for Pmod IP installation for Arty S7. I am having trouble figuring out code for ADC instantiation within my Verilog code. Can someone please help me with example code for AD1? Thank you

[Hi, Looking for 4 channel ADC with compatible FPGA board]

Hi JColvin,

Thank you for the reply. I think we can work around voltage by using a resistor in the circuit. 

Do you think if we use USB104 A7: Artix-7 with Zmod Scope 1410-105 setup would work?

Also we need to give out differential voltage signals again at around ~50 kHz as an output. Are Pmod accessories like this compatible with USB104 A7?

https://store.digilentinc.com/pmod-da3-one-16-bit-d-a-output/

https://store.digilentinc.com/pmod-amp2-audio-amplifier/

Thank you

Rohan

 

 

[Hi, Looking for 4 channel ADC with compatible FPGA board]

Hi Everyone,

I am a postdoc at Johns Hopkins Hospital. We are looking for a system to take in signal from 4 photo-multiplier tubes (output signal: 1-10 V, ~50 kHz) as an input to the FPGA board. We are not sure right now of logic slices we need. Do you have any suggestions for compatible ADCs and FPGA development boards?

Thank you