Rohan_C

Hello, I am using Pmod AD1 for simultaneous signal conversion from 2 photomultiplier tubes. I followed all the steps for Pmod IP installation for Arty S7. I am having trouble figuring out code for ADC instantiation within my Verilog code. Can someone please help me with example code for AD1? Thank you

Hi JColvin, Thank you for the reply. I think we can work around voltage by using a resistor in the circuit. Do you think if we use USB104 A7: Artix-7 with Zmod Scope 1410-105 setup would work? Also we need to give out differential voltage signals again at around ~50 kHz as an output. Are Pmod accessories like this compatible with USB104 A7? https://store.digilentinc.com/pmod-da3-one-16-bit-d-a-output/ https://store.digilentinc.com/pmod-amp2-audio-amplifier/ Thank you Rohan

Hi Everyone, I am a postdoc at Johns Hopkins Hospital. We are looking for a system to take in signal from 4 photo-multiplier tubes (output signal: 1-10 V, ~50 kHz) as an input to the FPGA board. We are not sure right now of logic slices we need. Do you have any suggestions for compatible ADCs and FPGA development boards? Thank you