I have a Genesys ZU-5EV running HDMI demo project which is all operating fine.
However, when I attach a TerasIC FMC Loopback to the board, the power up sequence stops. With the FMC loopback attached the AUX Power LED (LD19) comes on but the MAIN Power LED (LD20) does not and then the FPGA will not boot, or enter INIT mode (as signified by LD16).
The FMC Loopback board works ok on other dev boards (i.e. Enclustra XU6-ST1).
Question
JFreshwater
I have a Genesys ZU-5EV running HDMI demo project which is all operating fine.
However, when I attach a TerasIC FMC Loopback to the board, the power up sequence stops. With the FMC loopback attached the AUX Power LED (LD19) comes on but the MAIN Power LED (LD20) does not and then the FPGA will not boot, or enter INIT mode (as signified by LD16).
The FMC Loopback board works ok on other dev boards (i.e. Enclustra XU6-ST1).
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now