ECLYPSE Z7 Power failure

[JS123]

Hi,

I've bought an Eclypse Z7 and I've been working on it for some time now.

Yesterday I plugged a micro-USB into the micro-AB-USB (OTG port), and the board's LEDs imediately dimed-off, and the board doesn't boot anymore in any boot configuration mode. It seems to be dead.

The USB cable I plugged to the board was not connected to anything else; The board was in JTAG boot mode and operating normally.

 

Since I'm working remotely, is there any test that I could do to diagnose it without lab equipment?

Which diagnostic procedure should I follow otherwise?

 

Kind regards,

[artvvb]

Hey JS123,

I've reached out internally about your question and will let you know when I hear back.

Thanks,

Arthur

[artvvb]

Hey @JS123

Some form of additional equipment would be required to diagnose the problem. If you'd like to pursue troubleshooting further, could you let us know if you have access to a DMM and/or an oscilloscope?

Thanks,

Arthur