Jump to content
  • 0

Changing the digital I/O power-up/reset state of the USB-1208LS and USB-1024LS


Fausto

Question

(NOTE: If you are not qualified to accomplish this task, as these 0 Ohm shunts are fabricated using fine pitch components, please locate a qualified solder resource in your area.  Any modifications to the device voids the warranty and there is no repair service for the device.)

By removing the unit from the blue case, and with some skilled de-soldering and re-soldering, any or all ports can be set for pull-down instead of the default pull-up.  If you are handy with solder/desolder equipment for tiny surface mount zero-ohm resistor(s), then the change can be performed in the field.   Here are the details:

Note:  The USB-1024LS uses the same PCB as the USB-1208LS.   For the USB-1208LS, only ports A and B apply, but the USB-1024LS has 3 pull locations (for A, B, and C).

On the LED side, locate the RN1, RN3, & RN5 resistor packages. You will find the zero ohm resistors with the 'L' and 'H' pads near by.  By default, the resistor networks are soldered to ‘H’.  An experienced user can move (the zero ohm jumper) to ‘L’, which will make the respective port pull down (RN1/R69 is for port A, RN3/R70 is for port B, and RN5/R71 is for Port C).  In summary, move the zero ohm jumper/resistor, do not move the resistor networks (RNs).

 

image.png

 

Link to comment
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Guest
This topic is now closed to further replies.
×
×
  • Create New...